'Serial USB Terminal' is a line-oriented terminal / console app for microcontrollers, arduinos and other devices with a serial / UART interface connected with a USB to serial converter to your android device.
This app supports USB to serial converters based on
- FTDI FT232, FT2232, ...
- Prolific PL2303
- Silabs CP2102, CP2105, ...
- Qinheng CH340
and devices implementing the USB CDC protocol like
- Arduino using ATmega32U4
- Digispark using V-USB software USB
- BBC micro:bit using ARM mbed DAPLink firmware
To connect USB to serial converters, your android device must support USB OTG aka. USB host mode. Most devices support this today, but in case of issues check with one of the various USB test apps, if host mode is enabled in your android kernel.
All features in this app are free. In-App purchase is only used for the 'Donate' option.
Looking for source code? Here you find a simplified variant of this app:
https://github.com/kai-morich/SimpleUsbTerminal
"Serial USB Terminal" عبارة عن تطبيق طرفي / وحدة تحكم موجه للخطوط لأجهزة التحكم الدقيقة والأردوينو والأجهزة الأخرى مع واجهة تسلسلية / UART متصلة مع USB إلى محول تسلسلي لجهاز الروبوت الخاص بك.
هذا التطبيق يدعم USB إلى المحولات المتسلسلة على أساس
- FTDI FT232 ، FT2232 ، ...
- PL2303 الغزير
- Silabs CP2102، CP2105، ...
- تشينهينج CH340
والأجهزة التي تنفذ بروتوكول CDC الخاص بـ USB مثل
- اردوينو باستخدام ATmega32U4
- Digispark باستخدام برنامج V-USB USB
- بي بي سي مايكرو: بت باستخدام ARM mbed DAPLink البرامج الثابتة
لتوصيل USB بالمحولات المتسلسلة ، يجب أن يدعم جهاز Android الخاص بك USB OTG aka. وضع مضيف USB. معظم الأجهزة تدعم هذا اليوم ، ولكن في حالة وجود مشاكل تحقق مع واحد من مختلف تطبيقات اختبار USB ، إذا تم تمكين وضع المضيف في الروبوت kernel الخاص بك.
جميع الميزات في هذا التطبيق مجانية. تستخدم عملية الشراء داخل التطبيق فقط لخيار "التبرع".
تبحث عن رمز المصدر؟ هنا تجد البديل المبسط من هذا التطبيق:
https://github.com/kai-morich/SimpleUsbTerminal